Installing Your Dryer; Tools You Will Need; Before You Start; Step-By-Step Instructions - Insignia NS-FDRE67WH8A-C User Manual

INSTALLATION INSTRUCTIONS

Installing your dryer

Important
We recommend that you use a qualified installer to install your dryer.

Tools you will need

Phillips
screwdriver
Pliers

Before you start

Before you start installing your dryer, make sure that:
• The location you selected has a grounded electrical outlet. See Grounding requirements on page 16.
• For U.S. models, you have the correct type power cord (not included). See Electric requirements—U.S. only on
page 15.
Note: For Canadian models, the power cord comes pre-installed.
• Your exhaust ducting (not included) is made of rigid metal or flexible stiff-walled metal. See Ducting
requirements on page 12.
• GAS LINES (if you are installing a gas dryer) must meet all national and local codes.

Step-by-Step instructions

Step 1: Make sure that the floor is a solid, level surface
• Use a level to make sure that the floor where you are installing your dryer is level. This helps minimize vibration,
noise, and unwanted movement.
Step 2: Move your dryer to the location you selected
• Move your dryer to the location you selected, but do not push your dryer all the way back into the location. You
need to connect the power cord and ducting before you move your dryer into
Tip
For information about space requirements for a side-by-side installation, see
Installing your dryer and washer side-by-side on page 10.
Flat-head
Level
screwdriver
Pipe wrench
www.insigniaproducts.com
6.7 Cu. Ft. Front-Load Electric and Gas Dryers
Adjustable
Duct tape
wrench that
opens to 1"
(25 mm)
its final position.
Cutting knife
17