Installing Your Dryer; Tools You Will Need; Materials You Will Need; Before You Start - Insignia NS-TDRE67W1-C User Manual

INSTALLATION INSTRUCTIONS
Attach aluminum tape to the back of the dryer to seal the original dryer vent
6
hole.
Aluminum tape

Installing your dryer

Important: We recommend that you use a qualified installer to install your
dryer.

Tools you will need

Phillips screwdriver
Pliers

Materials you will need

• 3/8" gas dryer gas line (Gas model only)
• Three- or four-prong (dependent on owner's house) electric power cord
(electric model only)
• Exhaust dryer vent kit

Before you start

Before you start installing your dryer, make sure that:
• The location you selected has a grounded electrical outlet. See Grounding
requirements on page 21.
• For U.S. models, you have the correct type power cord (not included). See
Electric requirements on page 18.
Note: For Canadian models, the power cord comes pre-installed.
• Your dryer vent is in the correct location. See "Changing the dryer vent
location (optional)" on page 22 to change where your dryer vents.
• Your exhaust ducting (not included) is made of rigid metal or semi-rigid metal.
See Duct requirements on page 17.
• You have a 3/8 in. (1 cm) gas dryer gas line (if you are installing a gas dryer)
that meets all national and local codes. Before you connect the gas line, review
the gas line requirements in Gas requirements on page 20.
Elbow
Level
Adjustable wrench that opens
Pipe wrench
www.insigniaproducts.com
12-Cycle Electric and Gas Dryers
Flat-head screwdriver
to 1" (2.5 cm)
Aluminum tape
Cutting knife
25