Preparation For Assembly; Grill Assembly Instructions; Hood Handle Assembly - Pit Boss PTG2SS Instructions And User Manual

PREPARATION FOR ASSEMBLY

Remove grill and all packaging materials from the carton and place on a clean level
surface. Some parts are packed inside the grill body. Remove, unpack and inspect
these parts as well.
NOTE: Before using your grill, read the instructions and your manual.
For easier set-up and assembly, follow instructions of each step in the order they are
written as you look at the diagrams. If accessories mentioned in certain assembly
steps do not come with your model, skip that step and proceed to the next step that
applies to your model.
If you have any questions or need help, contact Customer Service at 1-877-303-
3134. Be sure to have the grill model number and serial number printed on the label
located on the inside surface of the rear leg. If you need replacement parts, look in
the Parts List section to find the exact parts you need. If you need a replacement
part under warranty, a proof of purchase will be necessary. You will be asked to
forward your proof of purchase. It is important to retain your receipt.

GRILL ASSEMBLY INSTRUCTIONS

1

HOOD HANDLE ASSEMBLY

Place a Handle Bezel between each end of the handle and the grill hood then insert a
¼-20 x .50" bolt through the inside of the hood into each end of the handle. Tighten
the bolts.
5