Lp Regulator - Pit Boss PTG2SS Instructions And User Manual

• Never fold or transport grill while LP Cylinder is attached.
• Never refill a 1 lb. cylinder.
The LP Gas Cylinder, for use with this LP gas grill, must meet the following
requirements:
1. 1 lb. capacity.
2. Contructed and marked in accordance with Specifications for LP Gas Cylinders
of the U.S. Department of Transportation (DOT) or the National Standard of
Canada, CAN\CSA-B339, Cylinders, Spheres and Tubes for Transportation of
Dangerous Goods; and Commission, as applicable (See collar for marking).
3. Marked "PROPANE. "
4. Provided with a cylinder connection device that is compatible with the grill's
connection.

LP REGULATOR

WARNING - To reduce the risk of serious injury or death from fire or explosion:
• Clean and inspect the gas regulator before each use of the outdoor cooking gas
appliance. Replace the gas regulator prior to being used if there is evidence of
excessive abrasion or wear.
• Use only the gas regulator assembly that has been supplied with this gas grill.
Do not use a regulator from another manufacturer. A replacement gas regulator
must be specified by this grill's manufacturer before using.
• Always check for gas leaks when you connect and disconnect the regulator
to the LP Gas Cylinder, especially after a period of storage (for example, over
winter).
Any use or alteration of this unit inconsistant with these instructions could
be hazardous and will void your warranty.
NOTE: If the regulator assembly is not working properly and you need a replacement,
contact: Customer Service at 1-877-303-3135. Be sure to have the grill model
number and serial number printed on the label located on the inside surface of the
rear leg.
If you need a replacement part under warranty, a proof of purchase will be
necessary. You will be asked to forward your proof of purchase. It is important to
retain your receipt.
9