Pit Boss PTG2SS Instructions And User Manual page 22

support bracket (Fig. 7).
4. Slide U-Tube burner to the left so that the end of the burner is off of the valve
nozzle and inside the firebowl. Lift the venturi end of the burner up first then
slide the burner out from under the electrode (Fig. 8).
5. Use a pipe cleaner to clear insect nests or debris from the inlet hole of Main
Burner (Fig. 9).
6. Open up the burner holes (Fig. 9) with a small nail or wire. Use a non-metalic
brush to remove food particles and corrosion from the burner surfaces.
7. Check the Electrode to see if it is loose. If so, tighten the screw holding
the Electrode to maintain 3/16" gap between Electrode tip and burner.
NOTE: Before next step, you may wish to clean the rest of the grill. See
"Cleaning the Grill" Section.
8. After Cleaning, refit the burner. If the grill is to be stored, the burners may be
wrapped in a protective cover such as aluminum foil or plastic wrap to help
keep insects out.
NOTE: When refitting the burner, be sure the burner is positioned correctly.
The valve nozzle should protrude inside the Venturi end of the burner (Fig. 10).
Replace the bolts that fasten the burner flange to the burner bracket.
21