Samsung 8340 User Manual page 14

pRoGRAMMING yoUR REMoTE CoNTRoL USING THE AUToMATIC
SEARCH METHoD
If the Quick Programming procedure did not work, follow the instructions below. This remote
control programming method allows you to control your TV and your audio system.
NOTE: When you have programmed the remote control to your audio system, you will no
longer be able to adjust the volume on your TV, only on your audio system. However, this
setting can be modified by following the instructions on page 16 (see the Change How Your
Remote Control is Programmed section).
1. Turn on your TV and audio system. Program your TV first.
2. Hold down and
both buttons.
3. Press 9–9–1 on the remote control. The red light will blink twice.
4. Then press 1 if you are looking for a TV code or 3 if you are looking for an audio system code.
5. Point the remote control at your TV or audio system, then press and release the CH+ button
until the device that you are programming turns off. You may need to press CH+ several
times in order to make this happen.
6. When the device turns off, press
programming procedure did not work, repeat steps 2 to 5.
7. To program your audio system, repeat steps 2 to 5.
8. When your remote control has been programmed, we strongly recommend that you change
the volume control on your TV via the Equipment Settings (see the Equipment Settings
section on page 16).
For further information, visit videotron.com/terminal-support.
14
until the red light under
to lock the code. The red light will blink twice. If this
blinks twice, then release