OC-2 SERIES OF PRINTERS USER'S GUIDE
Note: Do not force the battery into the battery cavity.
When inserted properly, the battery easily slides and locks
into place. If the battery does not easily slide into place,
re-insert the battery.
6. Close the printer cover (Figure 13).
Figure11
7. Charge the battery (batteries are shipped uncharged). For
more information, see "Charging the battery" on page 4.
Removing the battery
1. Lift the battery up and out of the battery cavity while
sliding it to the left (Figure 14).
2. Remove the battery from the battery cavity (Figure 15).
Figure14
Charging the battery
The battery status LED will glow red if the battery charge is
low and the printer is powered on. (For more information, see
"Using the control panel" on page 12.) Charge the battery as
follows:
1. Verify the battery is installed correctly.
Figure12
Figure13
Figure15
4