Printing A Self-Test - Datamax OC2 BT Technical Manual And User Manual

OC-2 SERIES OF PRINTERS USER'S GUIDE
Figure20
6. Close the printer (Figure 22). The printhead cover snaps
into place when completely closed.
7. Push the Media Function button 1-2 times to align the
media.
8. At either edge of the printer cover are serrated corners.
Tear the media by pulling up and away from the printer
(Figure 24).
Warning: The tear bar and printhead cover surface may be
hot and/or sharp. Use caution when handling the printhead
and tear bar.
Figure 23

Printing a self-test

1. Press and hold the power button for approximately three
(3) seconds until printing begins. For information on button
functions, see "Using the control panel" on page 12.
2. After printing begins, release the power button. A self-test
label will print showing parameters, as described on page
10.
Figure21 Figure 22
Figure 24
8