MICROFLASH 4TE PRINTER USER'S GUIDE
Charging the Battery
To charge the battery, you must first remove the red
battery isolator labels.
If the battery is low when the printer "wakes up," the
printer sounds three short beeps. Plug the AC Adapter
into an appropriate power source. The Charge LED
turns red when charging and turns green when fully
charged. (For more information on the Charge LED, see
Audio Indicators and LEDs on page 10
charge takes approximately 3 to 4 hours.
Caution: To obtain full battery capacity, a new battery
must cycle through two to three charges. To restart a
charge, unplug the power cord. Wait 30 seconds, then
replug the power cord.
If your printer is installed with external charge
capabilities, you can also charge your printer using
Datamax-O'Neil approved accessories. For more
information, see
Determining Battery Condition
To determine the battery's condition, print a self-test.
For more information, see
page 8
. The battery voltage varies between 6.2 and 8.4
volts.
Caution: There is a risk of explosion if the battery is
replaced by an incorrect type. Dispose of used
batteries according to the instructions.
Using External Charging on page 15
Printing a Self-Test on
4
.) A complete
.