Workout Mode; Pausing Or Stopping - Schwinn Classic Cruiser Assembly & Owners Manual

Resistance Shifter
The Resistance Shifter controls the level of resistance that
is applied to the flywheel. The selected resistance level is
pointed to by the lower "star burst" of the Schwinn
logo. There are seven levels of resistance (1-7) on the
exercise bike.
Adjust the Resistance Shifter to increase or decrease the
resistance at any time during your workout.
Media Rack
Your fitness machine is equipped with a Media Rack above
the Handlebars. The Media Rack secures your mobile
device, or other media. Adjust the lower part to the lowest
setting for your mobile device. Place your device on the
lower part of the Media Rack and, while holding the device
in place, slide down the upper part until your device is
secure between the lower and upper parts.

Workout Mode

The machine starts Workout Mode when it is plugged in or
if it receives a signal from the RPM sensor as a result of
pedaling the machine.
Pausing or Stopping a Workout / Auto Shut-Off (Sleep Mode)
If the Console does not receive any input in approximately 2 minutes, it will automatically
shut off.
®
Workout Timer
Your fitness machine is
equipped with a 20 minute Workout Timer. Gently turn the
face of the Timer clockwise 3/4 of the way around (past
15), and then to the desired amount of time and release it.
The Workout Timer begins counting down immediately, and
will make an audible sound when the time ends.
Note: Never turn the face of the Timer counter-
clockwise during the initial 3/4 of the way around winding.
This may damage the Timer.
22
Quality