Manage The Router Information Protocol Settings - NETGEAR Nighthawk AC1900 D7000v2 User Manual

Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000v2
5. In the IP Address fields, enter the LAN IP address for the modem router.
6. In the IP Subnet Mask fields, enter the LAN subnet mask for the modem router.
7. Click the Apply button.
Your settings are saved.
If you changed the LAN IP address of the modem router, you are disconnected when the changes take
effect.
To reconnect, close your browser, relaunch it, and log in to the modem router at its new LAN IP address.

Manage the Router Information Protocol Settings

Router Information Protocol (RIP) lets the modem router exchange routing information with other routers.
By default, RIP is enabled in both directions (in and out) without a particular RIP version.
To manage the RIP settings:
1. Launch a web browser from a computer or mobile device that is connected to the network.
2. Enter http://www.routerlogin.net.
A login window opens.
3. Enter the modem router user name and password.
The user name is admin. The default password is password. The user name and password are
case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
5. From the RIP Direction menu, select the RIP direction:
• Both. The modem router broadcasts its routing table periodically and incorporates information that
it receives. This is the default setting.
• Out Only. The modem router broadcasts its routing table periodically but does not incorporate the
RIP information that it receives.
• In Only. The modem router incorporates the RIP information that it receives but does not broadcast
its routing table.
6. From the RIP Version menu, select the RIP version:
• Disabled. The RIP version is disabled. This is the default setting.
• RIP-1. This format is universally supported. It is adequate for most networks, unless you are using
an unusual network setup.
• RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the routing data in RIP-2
format. RIP-2B uses subnet broadcasting. RIP-2M uses multicasting.
7. Click the Apply button.
Your settings are saved.
Manage the WAN and LAN Network Settings
146