NETGEAR Nighthawk AC1900 D7000v2 User Manual page 53

Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000v2
10. Enter the cable or fiber settings as described in the following table.
Field
Transfer Mode
DSL Mode
Multiplexing Method
VPI
VCI
Use VLANID
Priority (0 ~ 7)
Encapsulation
Login
Password
Service Name
Connection Mode
Description
These settings are not disabled but do not apply to a cable or fiber connection.
You can ignore these settings.
Unless you changed the physical WAN interface settings so that the modem
router must use the Ethernet WAN interface (see
Connection Preference on page 140), these settings are not disabled.
However, these settings do not apply to a cable or fiber connection and you
can ignore them.
Select the Use VLANID check box and enter the VLAN ID, as indicated by
your ISP.
A VLAN ID might be required if you subscribe to both Internet service and
IPTV service. If your ISP did not provide you with a VLAN ID, leave the Use
VLANID check box cleared, which is the default setting.
If your ISP provided you with a VLAN ID and a priority value, enter the priority
value, which is a number from 0 to 7.
You can enter a priority value only in combination with a VLAN ID. If your
ISP did not provide you with a priority value, leave the default setting (0).
For a PPP over Ethernet (PPPoE) connection, select PPPoE (PPP over
Ethernet) from the menu.
Note PPP over ATM (PPPoA) is not supported for a cable or fiber
connection.
Enter the login name that you use to log in to your Internet service, as
indicated by your ISP.
This login name is often an email address.
Enter the password that you use to log in to your Internet service, as indicated
by your ISP.
Enter the service name that you use to log in to your Internet service, as
indicated by your ISP.
Often, a service name is not required.
Select how the Internet connection functions:
• Always On. Once the Internet connection is established, it remains
active. This is the default setting.
• Dial on Demand. When someone attempts to connect to the Internet,
the Internet connection is established. When the idle time-out period
expires, the Internet connection is terminated.
• Manually Connect. You must connect to the Internet manually.
Manage the Internet Settings Manually
53
Change the Physical WAN