Detailed Sensor Set Up And Mounting - La Crosse Technology C84343 Instructional Manual

2. Install 2-AA batteries according to polarity and replace battery cover.
1. Use the hole at the top to hang your sensor from the back using a nail.
2. Mount your sensor on a north-facing wall or in any shaded area. Under an eave or deck rail is preferred.
3. The maximum wireless transmission range to the weather station is up to
4. Be sure your sensor is mounted vertically, to allow moisture to drain out properly.
TX
∙ Press TX to send a signal
∙ Press F/C to select Fahrenheit or
Celsius display on sensor.
Optional: insert 3 AA batteries into your station to maintain time/date in the event of a power outage.
1. Place your station near an outlet. Power cord is required for operation.
2. Use the mounting holes on the back to place your station on a wall.
3. Use the pull down stand on the back of your station to place on a desk or counter.
4. Your station should remain in good Wi-Fi range of your wireless router to use all the
For more information on manually setting you weather station see
Wireless Essential Weather Station

Detailed Sensor Set Up and Mounting

LTV-TH2 Thermo-Hygro Sensor
1. Slide the battery cover off the front of your sensor.
Or, insert one mounting screw through the front of your sensor.
400 feet (121 meters) in open air, not including walls or floors.
F/C
1. Insert the power cord into a wall outlet then into your station.
remote monitoring options using the La Crosse View™ app.
Mounting:
Hole for
mounting
LED Light
Battery Cover
C84343
Mounting:
page 20.
Page | 10