Baffle Removal - Quadra-Fire CB1200M-MBK Owner's Manual

2. Exhaust Blower Replacement
Remove existing blower:
a. Use proper shut down procedures to shut down the
appliance and let it completely cool and then unplug it.
b. Use an 11/32" wrench or nut driver to loosen and
remove the (6) nuts holding motor mount plate to the
blower housing on your appliance.
c. Remove washer from beneath the terminal ring on the
grounding wire.
d. Pull motor/mounting plate from blower housing.
e. Scrape off old gasket material from blower housing.
Install new blower:
f. The blower and blower housing is shipped as a appli-
ance. It is necessary to separate them at this point if you
are using the existing blower housing already installed
on the appliance:
g. Follow steps 2 and 3 above. Discard or set aside the
new blower housing.
h. Carefully remove gasket from new housing and set onto
the blower housing.
Re-install blower to blower housing:
i. Install blower on housing ensuring that wiring exits
facing the 8 o'clock position. Place the washer and then
the grounding wire on nearest mounting plate stud.
j. Use nuts removed in step b to secure blower to housing.
k. Re-connect wiring (use jumper wire if necessary).
Re-connect power supply.
November 30, 2017
D. Baffle Removal
a. Use proper shut down procedures to shut down the
appliance and let it completely cool down.
b. Open right side panel and then open the door.
c. The 2 baffles are located at the top inside of firebox.
d. Place your hand on the baffle and slide it up and the
bottom edge will fall down and then you can lift the
baffle out. Repeat for the other side.
1. Remove Baffle to Access Heat Exchanger
Tubes and Firebox Exhaust Exits
a. Open the upper right side panel door and then open
the glass door.
b. The 2 baffles are located at the top inside of firebox.
c. Place your hand on the baffle and slide it up and the
bottom edge will fall down and then you can lift the
baffle out. Repeat for the other side.
d. Re-install in reverse order.
7014-259B
CB1200 FREESTANDING
23