Baffle & Brick Set Removal - Quadra-Fire CASTILE-MBK-B Owner's Manual

f. To remove blower from the housing, remove 2 screws
in the front of the housing and very carefully bend the 2
housing sides out and bend the back of the housing away
from the blower. This allows for room to access the back
2 screws and nuts (4 total) that is securing the blower to
the housing.
g. Remove blower and replace with new blower.
e. Re-install in reverse order.
Loosen (do not remove) 2
screws on each side and lift
off blower housing
Figure 21.1
D. Baffle & Brick Set Removal
1. Follow proper shutdown procedures.
2. The top baffle has a hook on the bottom left side that
rests on the top lip of the cast brick. There is a tab on
the bottom right side that hooks into the side bracket.
Remove the top baffle by first pulling the baffle forward
until back edge drops down. Then slide baffle back until
the front edge clears the shelf that it had been resting on.
Figure 21.2
3. The top baffle must be removed before you can remove
the right and left brick. Remove the right brick by hold-
ing top lip of brick and lifting up, then push outside edge
back. Slide brick to the right until it is flush with the firebox.
Rotate the inside edge of the brick forward and remove
brick. Repeat for left brick. Figure 21.3.
November 27, 2017
Remove left side
panel and disconnect
blower wires
Convection Blower
& Housing
7021-155F
CASTILE FREESTANDING
Figure 21.2
Remove Right
& Left Brick
Figure 21.3
Right Brick
Removed
Vacuum
Exhaust Area
Figure 21.4
21