Furuno FSV-85 Installation Manual page 4

SAFETY INSTRUCTIONS
WARNING
If a steel tank is installed on a wooden
or FRP vessel, take appropriate
measures to prevent electrolytic
corrosion.
Electrolytic corrosion can damage the
hull.
Be sure to power each unit with proper
voltage.
Connection of an improper power supply
can cause fire or damage the equipment.
ii
CAUTION
Maximum speed while the transducer is
projected or being raised or lowered
is as below, to prevent damage to the
transducer.
Projected
Max. 18 kn
Ground the equipment to prevent
electrical shock and mutual
interference.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Standard
compass
Processor Unit 1.45 m
Control Unit
0.35 m
FSV-8501
Sub Control Unit
0.90 m
FSV-853
IF Unit 0.80 m
Raising/
Lowering
Max. 15 kn
Steering
compass
0.90 m
0.30 m
0.55 m
0.50 m