Furuno FSV-85 Installation Manual page 31

Transducer cable
If the transducer cable is not quite long enough, unfasten the cable clamp to release
the cable.
Unfasten cable clamp.
Ground
Ground the processor unit and the hull unit, using an IV-8 sq. wire or copper strap, to
prevent electrical shock. The transceiver unit also must be grounded, also with an IV-
8 sq. wire or copper strap of 50 mm width. The transceiver unit is supplied with a cop-
per strap.
Cable between Hull Unit and Transceiver Unit
The length of the cable between the hull unit and transceiver unit is 8 m. Arrange it as
shown below.
TRANSCEIVER
UNIT side
0.38 m
Transducer cable
(10S2320, 16 pcs.)
Clamp point
VV-SBCJ-0.3x14P8 (8 m)
7.2 m
0.07 m
2. WIRING
Clamp point
HULL UNIT
CONTROL BOX
0.28 m
side
0.07 m
2-3