Choose "On" to dim the projector lamp which will lower power
consumption, extend the lamp life and reduce noise. Choose "Off"
to return normal mode.
<Note> Gray out ECO mode item while either Lumisense or
BluelightShield item is "On".
Choose "On" to turn on High Altitude mode. Operate the fans at
full speed continuously to allow for proper high altitude cooling of
Turn Off Mode
The projector will automatically shutdown when there is no signal
input after the allocated time. (default is 15 minutes)
Menu Display Time
Choose the OSD menu display time. (Default is 15 seconds). Select
"Manual" to turn off main menu/one direct-key menu manually by
AC Power On
Choose "On" to power on projector while AC power plug in.
Control Panel Lock
Default is set to "Off".
Lamp Hour Elapse
Displays the lamp's elapsed operating time (in hours).
Activate this function to display a reminder to change the lamp 30
hours before its expected end-of-life.
Lamp Hour Reset
Press the "ENTER" button and choose "Yes" to turn the lamp hour
counter to 0 hours.
Note: Functions vary depending on model definition.
Standard: Properly shuts down the projector after fan
Instant Resume: Resumes the system when the Power button
is pressed again within 2 minutes.
Enable "Child Lock" to disable the power key on projector
while in the standby mode to avoid power trigger from
children. (Take effect after power off).
Disable "Child Lock" temporarily to turn on projector by
quick key, holding the power key on projector for 3 seconds.
No need to lock any key after power on.
Enable "Full Lock" to lock all keys on projector. (Take effect
once done the setting; show warning message while user
Disable "Full Lock" function, press "Power" key for 7 seconds.
And then, the OSD of "Control Panel Lock" is set to "Off" and
not required to go back to "Full Lock" again.
Pop up a warning message: To disable "Full Lock" function,
press "Power" key for 7 second, while user presses any key on
keypad panel under "Full Lock" mode.