Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Avenview HDM-C6MWIP4K-SET
Summary of Contents for Avenview HDM-C6MWIP4K-SET
- Page 1 VIDEO WALLS VIDEO PROCESSORS VIDEO MATRIX SWITCHES EXTENDERS SPLITTERS WIRELESS CABLES & ACCESSORIES Control Your Video PRODUCT MANUAL Model: HDM-C6MWIP4K-SET M-Series - 4K HDMI over IP with Video Wall & Matrix Support Encoder and Decoder Rev. 00 - 10/2017...
- Page 2 Except as set forth in Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products of Avenview Inc. is strictly prohibited.
-
Page 3: Table Of Contents
2.4.1 FRONT PANEL (SENDER/ENCODER, HDM-C6MWIP4K-S)..........6 2.4.2 REAR PANEL (SENDER/ENCODER, HDM-C6MWIP4K-S) ..........6 2.4.3 FRONT PANEL (RECEIVER/DECODER, HDM-C6MWIP4K-R)..........7 2.4.4 REAR PANEL (RECEIVER/DECODER, HDM-C6MWIP4K-R)..........7 INSTALLATION (HDM-C6MWIP4K-SET) POINT to POINT............8 3.1 IP MATRIX SWITCH GUIDE........................8 3.2 SINGLE SWITCH NETWORKING GUIDE ..................9 3.3 NETWORKING GUIDE ........................10 4. -
Page 4: Getting Started
• Removal, installation, and set-up service charges. SAfETy GUIDELINES The HDM-C6MWIP4K-SET M-Series - 4K HDMI over IP Encoder and Decoder has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipments, the HDM-C6MWIP4K-SET should be used with care. -
Page 5: Regulatory Notices Federal Communications Commisiion (Fcc)
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Avenview is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment. -
Page 6: Introduction
The Avenview HDM-C6MWIP4K-SET, HDMI H.264 IP Videowall and Matrix 4K Decoder/Encoder delivers end-to-end streaming media over IP networks. The HDM-C6MWIP4K-SET is composed of two units a Decoder and an Encoder. The Decoder H.264/MPEG-4 AVC video compression format, it receives the encoded IP signal through LAN port and decodes... -
Page 7: Package Contents
PACKAGE CONTENTS Before you start the installation of the HDMI Extender, please check the package contents. HDM-C6MWIP4K-SET HDM-C6MWIP4K-S) (HDM-C6MWIP4K-R) Power Adapter (+12V DC 1A)+International Adapters Right and Left Ear Rack Sets Phoenix connector (Male, 3.5 mm, 3 pins) x3 Sender... -
Page 8: Application Diagram
APPLICATION DIAGRAM www.avenview.com Rev. 00 - 10/2017... -
Page 9: Panel Description
/sending commands to RS 232 controllers. 5 seconds on power up to restore factory defaults *Note: Local output will display resolutions beyond the capabilities of the encoder. See Resolution Table for supported encoder resolutions. www.avenview.com Rev. 00 - 10/2017... -
Page 10: Front Panel (Receiver/Decoder, Hdm-C6Mwip4K-R)
RS 232-1: Debug use RS 232-2: RS-232 Data pass-through port for receiving /sending commands to RS 232 controllers. Reset Button: Reboots the device. Hold down for 5 seconds on power up to restore factory defaults www.avenview.com Rev. 00 - 10/2017... -
Page 11: Installation (Hdm-C6Mwip4K-Set) Point To Point
INSTALLATION (HDM-C6MWIP4K-SET) POINT to POINT To setup Avenview HDM-C6MWIP4K-SET please follow these steps for connecting to a device: Turn off all devices including monitors / TV. Connect an HDMI source (such as a Blu-Ray Disc player or PC) to the Encoder HDM-C6MWIP4K-S. -
Page 12: Single Switch Networking Guide
The following brands are recommended and was tested resulting in stable working conditions. HUAWEI brand Network Switch for Video over IP applications Switching capacity: 336 Gbit/s Models: S5720-28X-PWR-SI-AC, S5720-28X-PWR-SI-DC HUAWEI Brand Network Switch for Video over IP applications Switching capacity: 336 Gbit/s Models: S5720-28X-PWR-SI-AC, S5720-28X-PWR-SI-DC S5720-52X-PWR-SI-ACF www.avenview.com Rev. 00 - 10/2017... -
Page 13: Networking Guide
NETWORKING GUIDE Avenview M-Series 4K HDMI over IP units can be networked together with a recommended Layer 2 Gigabit Smart Switches. As mentioned previously in section 3 the importance of calculation for the capacity of the switch meets the requirements of the number of encoders/decoders you have on your network. -
Page 14: Pc Configurator
SETTING A STATIC IP ON YOUR COMPUTER Before using the Avenview PC Configurator, please ensure you download the most recent version from the product HDM-C6MWIP4K-S Sender and HDM-C6MWIP4K-R Receiver website link /downloads PC control software. Refer to the chart above for correct version numbers. - Page 15 Adapter Settings, right click Local Area Connection, and then choose Properties. Double-click Internet Protocol Version 4 (TCP/IPv4). Select Use the following IP address. After configuring the settings in the following example, click OK. IP address: 169.254.2.5 Subnet mask: 255.255.0.0 Click OK. www.avenview.com Rev. 00 - 10/2017...
-
Page 16: Configuring Your Operating System
You can also configure the firewall in the Windows Security Alert window. When starting MaintainTool, the Windows Security Alert may display. If so, use the administrator privileges to select a network you allow this software to communicate on, for example select both private and public networks, and then click Allow access. www.avenview.com Rev. 00 - 10/2017... -
Page 17: Specifications
OPERATING TEMPERATURE -4˚ ~ 140˚F (-20˚ ~ 60˚C) -4˚ ~ 140˚F (-20˚ ~ 60˚C) STORAGE TEMPERATURE 20~90% RH (no condensation) 20~90% RH (no condensation) RELATIVE HUMIDITY *Note: See M-Series Latency Summary available here. www.avenview.com Page 14 Rev. 00 - 10/2017... -
Page 18: Supported Encoder Resolutions
SUPPORTED ENCODER RESOLUTIONS SUPPORTED DECODER RESOLUTIONS www.avenview.com Page 15 Rev. 00 - 10/2017... -
Page 19: Troubleshooting
4. Check that source device is powered on and the HDMI cable is connected. Check the displays are powered on and the correct input selection. Check the HDMI cable is plugged into the correct port. www.avenview.com Rev. 00 - 10/2017... - Page 20 UNSHIElLDED (UTP) ✶✶✶ ✶✶✶✶ ✶✶✶✶ SOLID SHIEl DED (STP) ✶✶✶ ✶✶✶✶ ✶✶✶✶✶ u NSHIEl DED (UTP) ✶ ✶✶ ✶✶ STRANDED SHIEl DED (STP) ✶ ✶ ✶✶ TERMINATION PLEASE USE EIA/TIA-568-B TERMINATION (T568B) AT ANY TIME www.avenview.com Rev. 00 - 10/2017...
- Page 21 PARTS: During the Warranty Period of of THREE (3) YEARS, Avenview will supply new or rebuilt replacements in exchange for defective parts of the product(s) at no cost if the product(s) is determined to have abide by Avenview’s published guidelines. Cost of Parts applicable to product(s) after Warranty Period. For part(s) costs, please contact support@avenview.com.
-
Page 22: Technical Support
Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of Avenview concerning such products or this documentation, for any interruption of service, loss or interruption of business, loss of anticipatory profits, or for punitive, incidental or consequential damages in connection with the furnishing, performance, or use of the Avenview hardware, software, or other products and documentation provided herein.
Need help?
Do you have a question about the HDM-C6MWIP4K-SET and is the answer not in the manual?
Questions and answers