Table of Contents
Advertisement
Power Control Operations
Example
The following command has the PX enter the load shedding mode.
config:#
loadshedding start
This section applies to outlet-switching capable models only.
Outlets on the PX device can be turned on or off or power cycled through
the CLI.
Besides, you can cancel the power-on process while the PX is powering
on ALL outlets.
You must perform this operation in the administrator mode. See
Different CLI Modes and Prompts
Turning On the Outlet(s)
This section applies to outlet-switching capable models only.
This command turns on one or multiple outlets.
#
power outlets <numbers> on
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
power outlets <numbers> on /y
Variables:
<numbers> is one of the options: all, an outlet number, a list or a
range of outlets.
Option
Description
all
Switches ON all outlets.
A specific outlet
Switches ON the specified outlet.
number
Chapter 8: Using the Command Line Interface
(on page 339).
485
Advertisement
Table of Contents
