Disassembling The Ground Stacked Array - L-Acoustics KIVA Manual

KIVA
WST SYSTEM
Rigging Procedures and Accessories
VERSION 1
1. Attach KIBU to the top of the first and would be bottom enclosure as described in section 6.1.1 steps 2 through 5.
Be sure to give attention to the warning and caution statements.
2. Physically lift the enclosure along with the KIBU and flip it so that the KIBU is now facing down and place the
assembly on a flat surface. When ever possible secure the KIBU to the surface so as to provide added security to the
assembly.
3. Position yourself in front of the assembly. Place the second enclosure above the now bottom enclosure (the Logo
must be on the left side of the front grill if you are facing the enclosure). Lower the second enclosure and align the
front attachment points with the attachment points on the bottom enclosure.
Position the top enclosure just to the left of the bottom one. Shift the top enclosure to the right: you will hear a click
sound that indicates that the two enclosures are locked together. Attach the rear angle bar. This procedure is
outlined in steps 2. through 5. of section 6.1.3 along with the warning and caution statements.
4. Repeat the procedure described above for all additional enclosures in the array.
!
In a stacked configuration where KIVA and KILO are implemented, the KILO enclosures must always
be positioned on the bottom of the Line Source Array.
Never position KILO in between two KIVA enclosures.
IMPORTANT
6.2.2

Disassembling the ground stacked array

Disassembling the ground stacked array is carried out in the opposite order of how it was assembled by reversing the
order described in steps 2. to 7. of section 6.1.4 (pay attention to the warning sign).
KIVA_RM_ML_1 w w w . l - a c o u s t i c s . c o m 16 en