Attaching Additional Enclosures - L-Acoustics KIVA Manual

4. Once you have reached the proper height and stabilize the assembly, release the angle bar from the bottom KILO
and retract the release pin in back of the KILO above it.
Figure 12: Setting the angle between the two KILO enclosures
5. Place the angle bar in the slot notating the angles in the back of the top enclosure, select the angle desired, and
release the pin so that it locks the selected angle in place.
The release pin will re-engage automatically into its initial position, if this does not happen it will be necessary to
change the positioning of the angle bar in the slot of the upper KILO until the pin locks into place.
!
Verify that the back of the enclosures are positively fastened by checking that each angle bar is
secured via the spring-loaded pin and that the pin is returned to the fully engaged position.
CAUTION
6.1.3

Attaching additional enclosures

KIVA_RM_ML_1
Angle Bar
w w w . l - a c o u s t i c s . c o m
Spring-loaded Pin
EN
13 en