Motherboard Features
CPU
•
Dual Intel Xeon 81xx/61xx/51xx/41xx/31xx series processors (Socket P) which offer 2 UPI (UltraPath Interconnect) of up
to 10.4GT/s
Note: Both CPUs need to be installed for full access to the PCI-E slots, DIMM slots, and onboard controllers. Refer
to the block diagram on page 16 to determine which slots or devices may be affected.
Memory
•
Integrated memory controller supports up to 1536GB of ECC Load Reduced DIMM (LRDIMM), Registered DIMM (RDIMM),
and Non-Volatile DIMM (NV-DIMM) DDR4 (288-pin) 2666/2400/2133 MHz modules in 12 slots
DIMM Size
•
Up to 128GB at 1.2V
Note 1: Memory speed support depends on the processors used in the system.
Note 2: For the latest CPU/memory updates, please refer to our website at http://www.supermicro.com/products/
motherboard.
Chipset
•
Intel C621
Expansion Slots
•
Two (2) PCI-Express 3.0 (x16) slots supported by CPU1 and CPU2
•
One (1) PCI-Express 3.0 x16 (x8 + x8) SMCI storage Slot (JSXB2)
•
One (1) PCI-Express 3.0 x16 SIOM LAN Port
BaseBoard Management Controller (BMC)
•
ASpeed AST 2500 Baseboard Management Controller (BMC) supports IPMI 2.0
•
One (1) dedicated IPMI LAN located on the rear IO backpanel
Graphics
•
Graphics controller via AST 2500 BMC (Baseboard Management Controller)
I/O Devices
•
SATA 3.0
•
RAID (PCH)
•
NVMe OcuLink Ports
Peripheral Devices
•
One (1) USB 3.0 port on the rear I/O panel (USB 0/1)
Note: The table above is continued on the next page.
Motherboard Features
Ten (10) SATA ports
•
I-SATA0~3, I-SATA4~7
•
S-SATA0/1
•
RAID 0, 1, 10
Four (4) NVMe OcuLink ports
•
JNVME1~4
13
Chapter 1: Introduction