Fluke Ti9 User Manual page 8

Saving Imager Data
The Imager saves displayed data on an SD card placed into the camera. See the
"Changing the SD Card" section for inserting and ejecting an SD card. The file
format set on the Imager determines how the measured information is stored on
the SD card. To store Imager data:
1. Point camera at the area of interest and pull the trigger to capture an image.
This will freeze the image in the display and bring up the Image Capture
menu.
2. Press the softkey labeled Store. If the SD card is in the Imager and there is
enough room left on the card, the information is stored.
Adjusting the Thermal Image
The Imager uses different colors or shades of gray to display the temperature
gradient of the area within the Imager's field of view. There are two
adjustments for changing how the Imager displays the image: Palette and
Range.
Selecting a Palette
The palette menu provides different thermal viewing patterns. Grayscale, Blue-
Red, High Contrast, and Ironbow are available in all four Imagers. The TiR1 and
Ti25 add Amber and Hot Metal to the list. To select a palette:
1. Press a until Palette appears over c.
2. Press the softkey labeled Palette to display the available palette options.
3. Press the softkey labeled Up or Down to move between the palette
options.
4. Press the softkey labeled Back/Done to set the Imager to the selected
palette.
Setting the Range
Viewing temperature (level and span) is set either automatically or manually.
To set the range, do the following:
1. Press a until Range appears over d.
2. Press the softkey labeled Range.
3. Press the softkey labeled Manual to set the Imager to manual ranging and
press the softkey labeled Auto to select auto ranging.
Fast Auto/Manual Range Toggle (Ti10, Ti25, TiR, TiR1)
When NOT in a menu mode, press F1 for ½ second to toggle between Auto
Range and Manual Range.