Table of Contents
Advertisement
Setting the Backlight
The backlight can be set to Auto-sensing or Full-Bright. To set the backlight:
1. Press a until Backlight appears over c.
2. Press the softkey labeled Backlight.
3. Press the softkey labeled Auto or Full-Bright.
To extend battery life, Auto-Sensing automatically adjusts backlight
brightness based on ambient light levels.
Maintenance
The Imager supplies maintenance-free operation. However, some precautions
should be followed to get the best and longest Imager performance.
Cleaning the Imager
Wipe the case with a damp cloth and a mild detergent. Do not use abrasives,
isopropyl alcohol, or solvents to clean the case or lens/window.
Battery Care
To get the best performance from the Imager's Nickel-Metal Hydride (NiMH)
battery, use the guidelines that follow.
To avoid damage to the Imager, do not leave the camera
exposed to a heat source or high-temperature
environments, such as an unattended vehicle in the sun.
Do not store the Imager on the charger for more than 24 hours as
reduced battery life may result.
Charge the Imager for a 2-hour minimum at least every six months to
maximize battery life. Without use, the battery will self-discharge in
approximately six months. Batteries stored for long periods may
require two to ten charging cycles before it reaches full capacity.
Always operate the Imager within the temperature range specified in
the specifications labeled Temperature – Operating.
Do not incinerate the Imager and/or battery. Go to Fluke's
website for recycling information.
W Caution
~ W Caution
Hide quick links:
Advertisement
Table of Contents
