Page 2
On page 3, under Unpacking the Imager, following the last bullet add: Note Fluke recommends the use of the supplied SD memory card with your thermal imager, and does not warrant the use or reliability of aftermarket SD memory cards of different brands or capacities.
Page 3
Manual Supplement Ti10, Ti25, TiR and TiR1 Users to view the battery condition icon. Removing the Imager from the charger before a full charge is indicated will deprive the battery of a full charge and thus shorten camera run time.
Page 4
Ti10, Ti25, TiR and TiR1 Users Manual Supplement • Charge the Imager for a minimum of 2 hours at least every six months to maximize battery life. Without use, the battery will self-discharge in approximately six month. Batteries stored for long periods may require two to ten charging cycles before the battery reaches full capacity.