Table of Contents
Advertisement
Aligning antennas
Aligning antennas
Before performing this task, check that hardware installation is complete (apart from
the network connections) at both the Master and Slave sites.
This task consists of the following procedures:
x
Starting up the units
x
Checking that the units are armed
x
Aligning antennas
x
Aligning separate antennas for spatial diversity
x
Monitoring received signal level
x
Disarming the units
Starting up the units
To connect one of the units to a management PC and start up both units, proceed as
follows:
1
Select the unit from which this process is to be controlled; either Master
or Slave. This is the 'local' unit.
Check that the management PC is connected to the local unit, powered up
2
and logged on.
Start the local unit.
3
4
Start the remote unit.
5
Log into the local unit as described in
page 6-6.
6-24
on page
6-24
on page
on page
6-25
on page 6-27.
on page
6-30
Chapter 6 Configuration and alignment
6-25
on page
6-27
Logging into the web interface
phn-2182_002v000
on
May 2011
Advertisement
Table of Contents
