Table of Contents
Advertisement
To install the Hot Plug HDD cage
1
Detach the chassis panels and remove the air baffle.
2
Connect the following cables to the SCSI backplane board:
a
SCSI cable
b
SCSI HDD 6 pin management cable
c
SCSI HDD power cable
3
Insert the Hot Plug HDD cage into the housing (1), then tighten
the four thumbscrews to secure it to the chassis (2).
4
Attach the other end of these cables to the corresponding
connectors on the mainboard.
Refer to "Mainboard layout" on page 14 for the location of the
connectors.
47
Advertisement
Table of Contents
