Table of Contents
Advertisement
52
Installing and removing storage
devices
The system supports one 3.5-inch and two 5.25-inch internal storage
devices. The system comes pre-installed with a floppy drive and a CD-
ROM drive. The empty 5.25-inch half-height bay allows you to install
additional drives such as another CD-ROM drive or a tape drive.
To replace the 3.5-inch floppy drive
1
Observe the ESD precautions and pre-installation procedures
described on page 37.
2
Disconnect the IDE and floppy drive cables from the old drive.
3
Press the release bracket on both sides of the drive carrier (1)
before pulling it out from the chassis (2).
3 Upgrading the system
Advertisement
Table of Contents
