44
Configuring the Hot Plug HDD cage
This section includes instructions for removing and installing the
Hot Plug HDD cage as well as procedures on how to install a hard disk
into the cage's hard disk carrier.
Note: The Hot Plug HDD cage feature is only applicable to the
Altos G510 model.
To remove the Hot Plug HDD cage
Important: Before detaching the Hot Plug HDD cage from the
chassis, make sure to first remove all hard disks from their carriers.
For instructions, refer to the succeeding section.
1
Remove the front bezel, inner front panel, side panel and air
baffle. Refer to the previous section for detailed intructions.
2
Disconnect the following cables from the cage:
a
SCSI cable
b
SCSI HDD 6 pin management cable
c
SCSI HDD power cable
3
Loosen the four thumbscrews that secure the cage to the chassis
(1).
3 Upgrading the system