Audio Settings - Kenwood KDC-220UI Instruction Manual

AUDIO SETTINGS

While listening to any source...
1 Press AUD to enter [AUDIO CONTROL] directly.
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press and hold to exit.
To return to the previous setting item, press
(or using the remote control) (for
1 Press AUD to enter [AUDIO CONTROL].
Press J / K to select an item, then press
2
AUDIO CONTROL
SUB-W LEVEL –15 to +15 (0)
BASS LEVEL –8 to +8 (+2)
MID LEVEL –8 to +8 (+1)
TRE LEVEL –8 to +8 (+1)
EQ PRO (This setting is stored to [USER].)
BASS ADJUST BASS CTR FRQ
BASS LEVEL
BASS Q FACTOR
BASS EXTEND
.
)
.
Adjusts the subwoofer output level.
Adjusts the level to memorize for each source.
(Before making an adjustment, select the source you
want to adjust.)
60HZ/80HZ/100HZ/200HZ or 60/80/100/200:
Selects the center frequency.
–8 to +8 (+2): Adjusts the level.
1.00/1.25/1.50/2.00: Adjusts the quality factor.
ON: Turns on the extended bass. ; OFF: Cancels.
MID ADJUST
TRE ADJUST
PRESET EQ
Default: XX
BASS BOOST
LOUDNESS
SUBWOOFER SET
LPF SUBWOOFER
SUB-W PHASE
FADER
BALANCE
MID CTR FRQ 0.5KHZ/1.0KHZ/1.5KHZ/2.5KHZ: Selects the
center frequency.
MID LEVEL –8 to +8 (+1): Adjusts the level.
MID Q FACTOR 0.75/1.00/1.25: Adjusts the quality factor.
TRE CTR FRQ 10.0KHZ/12.5KHZ/15.0KHZ/17.5KHZ: Selects
the center frequency.
TRE LEVEL –8 to +8 (+1): Adjusts the level.
DRIVE EQ/TOP40/POWERFUL/ROCK/POPS/EASY/JAZZ/NATURAL/
USER: Selects a preset equalizer suitable to the music genre.
(Select [USER] to use the settings made in [EQ PRO].)
[DRIVE EQ] is a preset equalizer that reduces noise outside the car or
running noise of the tyres.
LEVEL1/LEVEL2/LEVEL3 or LV1/LV2/LV3: Selects your preferred bass
boost level. ; OFF: Cancels.
LEVEL1/LEVEL2 or LV1/LV2: Selects your preferred low and high
frequencies boost to produce a well-balanced sound at a low volume
level. ; OFF: Cancels.
ON: Turns on the subwoofer output. ; OFF: Cancels.
THROUGH: All signals are sent to the subwoofer. ;
85HZ/120HZ/160HZ: Audio signals with frequencies lower than
85 Hz/120 Hz/160 Hz are sent to the subwoofer.
REVERSE (180°)/NORMAL (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
(Selectable only if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].)
R15 to F15 (0): Adjusts the rear and front speaker output balance.
L15 to R15 (0): Adjusts the left and right speaker output balance.
11
ENGLISH