Kenwood KDC-220UI Instruction Manual page 18

INSTALLATION/CONNECTION
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
[ terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 15)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the [ terminal of the car battery.
5 Detach the faceplate and reset the unit. ( 3)
Part list for installation
(A) Faceplate
(C) Mounting sleeve
(E) Extraction key
14
ENGLISH
Installing the unit (in-dash mounting)
(B) Trim plate
How to remove the unit
(D) Wiring harness 1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the holes on both sides of the trim plate, then pull it out.
3 Insert the extraction keys deeply into the slots on each side, then follow the arrows as shown on the
Orientate the trim plate as
illustrated before fitting.
illustration.
Do the required wiring.
( 15)
Hook on the top side
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
Dashboard of
your car