Audio Settings; Press And Hold - Kenwood KDC-X597 Instruction Manual

AUDIO SETTINGS
While listening to any source ...
1 Press the volume knob to enter
[FUNGION].
2 Turn the volume knob to select [AUDIO CONTROL]/ [AUDIO GRL], then press the
knob.
3 Turn the volume knob to make a selection (see the following table), then
press the knob.
Repeat step
3
until the desired item is selected or activated.
4
Press and
hold~
to exit.
(orusingRC-406)~~~~~~~~~~~~~~~~~~~~
1 Press AUD to enter
[AUDIO CONTROL]/ [AUDIO GRL].
2 Press JJrt../T to make a selection, then press ENT ........
• To return to the previous hierarchy,
press~.
Default: XX
SUB-W LEVEL -15 to+ 15
(0):
Adjusts the subwoofer output level.
BASS LEVEL -8 to +8 (0):
-MIDLEVEL--------=_
8
t~
+B(m: ____ Adju.sts the
le~el
to memorize for each source. (Before .
-------------------------=-------
makmg an adjustment, select the source you want to adjust.)
TRE LEVEL -8 to +8 (0):
14
BASS ADJUST BASS GR FRQ 60/80/ 100/200: Selects the center frequency.
-------------------------------------------~
BASS LEVEL -8 to +8
(0):
Adjusts the level.
-------------------------------------------------------------------------
BASS Q FACTOR 1.00/1.25/1.50/2.00: Adjusts the quality factor.
BASS EXTEND ON: Turns on the extended bass. ; OFF: Cancels.
MID ADJUST MID GR FRQ 0.5K/1.0K/1.5K/2.5K: Selects the center frequency.
----------------------------------------------------------
MID LEVEL -8 to +8
(0):
Adjusts the level.
MID Q FAGOR 0.75/1.00/1.25: Adjusts the quality factor.
TRE ADJUST TRE GR FRQ
TRE LEVEL
1 O.OK/12.5K/15.0K/17 .5K: Selects the center
frequency.
-8 to +8 (0): Adjusts the level.
PRESET EQ
BASS BOOST
LOUDNESS
BALANCE
FADER
NATURAU USER/ ROCK/ POPS/ EASY/TOP40/ JAW POWERFUL: Selects
a preset equalizer suitable to the music genre. (Select [USER] to use the
customized bass, middle, and treble settings.)
B.BOOST LV1/ B.BOOST LV2/ B.BOOST LV3: Selects your preferred bass
boost level.; OFF: Cancels.
LOUDNESS LV1/ LOUD LV1/ LOUDNESS LV2/ LOUD LV2: Selects your
preferred low and high frequencies boost to produce a well-balanced sound at
a low volume level.; OFF: Cancels.
L15 to R15
(0):
Adjusts the left and right speaker output balance.
R15 to F15
(0):
Adjusts the rear and front speaker output balance.
SUBWOOFER ON: Turns on the subwoofer output.; OFF: Cancels.
SET
I
SUB-W SET
HPF THROUGH: All signals are sent to the speakers.; 100HZ/ 120HZ/
150HZ: Audio signals with frequencies higher than 100 Hz/ 120 Hz/ 150Hz are
sent to the speakers.
LPF SUBWOOFER/ THROUGH: All signals are sent to the subwoofer.; 85HZ/ 120HZ/
LPF SUB-W 160HZ: Audio signals with frequencies lower than 85 Hz/ 120 Hz/ 160 Hz are
sent to the subwoofer.
SUB-W PHASE REVERSE/ REV (180°)/ NORMAL/ NORM (0°): Selects the phase of
the subwoofer output to be in line with the speaker output for optimum
performance. (Selectable only if a setting other than [THROUGH] is selected
for [LPF SUBWOOFER]/ [LPF SUB-W].)
SUPREME SET ON: Creates realistic sound by interpolating the high-frequency components
that are lost in MP3/WMA audio compression.; OFF: Cancels. (Selectable only
when playing back an MP3/WMA disc or a USB device, except iPhone/iPod.)
VOLUME OFFSET/ -8 to +8 (for AUX); -8 to 0 (for other sources): Presets the volume
VOL OFFSET adjustment level of each source. (Before adjustment, select the source you
(Default: 0) want to adjust.)
• 13•IIJI:iite1;.111:
[SUB-W LEVEL]/ [SUB-W SET]/ [LPF SUB-W]/ [SUB-W PHASE] is
selectable only if [SWITCH PRE] is set to [SUB-W]. (~ 4)
• [SUB-W LEVEL]/ [LPF SUB-W]/ [SUB-W PHASE] is selectable only if [SUB-W SET] is set
to [ON].