Cisco cBR 8 Configuration Manual page 137

Subscriber Traffic Management
Step 6
Step 7
Command or Action
• If you specified DOCSIS 1.0 cable modems
in Step 4, on page 126, use the following
commands:
1 qos-profile registered profile-id
2 qos-profile enforced profile-id
[no-persistence]
• If you specified DOCSIS 1.1 cable modems
in Step 4, on page 126, use the service-class
{enforced | registered} name command.
Example:
Router(enforce-rule)# service-class
enforced test
duration minutes avg-rate rate sample-interval
minutes[penalty minutes] {downstream |
upstream} [enforce]
Example:
Router(enforce-rule)# duration 10
avg-rate 500 sample-interval 10 penalty
120 downstream enforce
peak-time1 {hour | hour:minutes} duration
minutes avg-rate rate [peak-time2 {hour |
hour:minutes} duration minutes avg-rate
rate][duration offpeak-minutes avg-rate
offpeak-rate ] sample-interval minutes[penalty
minutes] {downstream | upstream}[enforce]
Example:
Router(enforce-rule)# peak-time1 6
duration 180 avg-rate 2 peak-time2 18
duration 180 avg-rate 2 duration 120
avg-rate 3 sample-interval 10 upstream
enforce
Router(enforce-rule)# peak-time1 6:30
duration 180 avg-rate 2 peak-time2 18:40
duration 180 avg-rate 2 duration 120
Cisco cBR Series Converged Broadband Routers Quality of Services Configuration Guide for Cisco IOS XE Fuji
Creating and Configuring an Enforce-Rule
Purpose
1 Specifies the registered quality of service
(QoS) profile that should be used for this
enforce-rule.
If you want to manage a cable
Note
modem that currently uses a
modem-created QoS profile,
you must first manually create
a new QoS profile on the CMTS
with the same QoS parameters
as the modem-created profile.
Then allow the modem to come
online using the manually
created profile before using this
command.
2 Specifies the quality of service (QoS)
profile that should be enforced when
users violate their registered QoS
profiles for DOCSIS 1.0 cable modems.
• For DOCSIS 1.1 (and later) cable modems,
identifies a particular service class with the
specified name for cable modem monitoring
in an enforce-rule.
Specifies the time period and sample rate used
for monitoring subscribers when legacy
monitoring is configured (Step 4, on page
Specifies peak monitoring periods when
peak-offpeak monitoring is configured
on page 126).
126).
(Step 4,
16.7.x
127