Table of Contents
Advertisement
when the maximum liquid level is reached.
You will hear a noticeable change of the
sound from the motor and notice that the suc-
tion power decreases. When this occurs,
switch the machine off. Disconnect the ma-
chine from the socket. Never pick up liquid
without the float body in place.
3.4
Emptying after wet pick-up
Before emptying the container, unplug the vacuum
cleaner. Disconnect the hose from the inlet by pulling
out the hose. Release the latch by pulling them out-
wards so that the motor top is released. Open up the
motor top from container. Always empty and clean
the container and the float system after picking-up
liquids. Never pick up liquid without the float system
and filter installed in the machine.
Empty by tilting the container backwards and pour
the liquids into a floor drain or similar.
Put back the motor top to the container. Secure the
motor top with the latches.
3.5
Emptying after dry pick-up
Remove the electrical plug from the socket before
emptying after dry pick-up. Check the filters and
dustbag regularly. Release the latch by pulling them
outwards so that the motor top is released. Open up
the motor top from container.
Cartridge filter: To clean the filter you can either
shake, brush or wash it. Wait until it is dry before you
reuse it.
Dustbag: check bag to ensure the fill factor. Re-
place dust bag if necessary. Remove the old bag.
The new bag is fitted by passing the carboard piece
with the rubber membrane through the vacuum inlet.
Make sure that the rubber membrane is passing past
the heightening at the vacuum inlet.
After emptying: Close motor top to the container and
secure the motor top with the latches. Never pick up
dry material without cartridge filter and dustbag fitted
in the machine. The suction efficiency of the vacuum
cleaner depends on the size and quality of the filter
and dust bag. Therefore - use only Original filter and
dust bags.
3.6
Push&Clean
The machine is equipped with a semi automatic filter
cleaning system. Push&Clean. The filter cleaning
system must be actuated latest when the vacuum-
ing performance is no longer sufficient. Regular use
of the filter cleaning feature increases the tool life of
the filter.
6
4
After using the cleaner
4.1
After use
Remove the plug from the socket when machine is not
in use. Wind up the cord starting from the machine. The
power cord can be wound up around the motor top or at
the container. Some variants have special storage places
for accessories.
4.2
Transport
•
Before transporting the dirt tank, close all the locks.
•
Do not tilt the cleaner if there is liquid in the dirt tank.
•
Do not use a crane hook to lift the cleaner.
4.3
Storage
•
Store the appliance in a dry place, protected from rain
and frost.
•
The machine shall be stored indoors only.
4.4
Recycling the cleaner
Make the old cleaner unusable.
1. Unplug the cleaner.
2. Cut the power cord.
3. Do not discard of electrical appliances with household
waste.
As specified in European Directive 2012/19/EC on
old electrical and electronic appliances, used electri-
cal goods must be collected separately and recycled
ecologically.
5
Maintenance
5.1
Regular servicing and inspection
Regular servicing and inspection of your machine must be
carried out by suitably qualified personnel in accordance
with relevant legislation and regulations. In particular, elec-
trical tests for earth continuity, insulation resistance, and
condition of the flexible cord should be checked frequently.
In the event of any defect, the machine MUST be with-
drawn from service, completely checked and repaired by
an authorized service technician.
5.2
Maintenance
Remove the plug from the socket before performing main-
tenance. Before using the machine make sure that the fre-
quency and voltage shown on the rating plate correspond
with the mains voltage.
The cleaner is designed for continuous heavy work. De-
pending on the number of running hours – the dust filter
should be renewed. Keep the vacuum cleaner clean with a
dry cloth, and a small amount of spray polish.
For Dust Class L machines (with type designation -2L) fol-
lowing applies:
During maintenance and cleaning, handle the machine in
such a manner that there is no danger for maintenance
staff or other persons.
In the maintenance area
*)
Optional accessories / Option depending on model
Original instruction
Hide quick links:
Advertisement
Table of Contents
