Dynojet Power commander V Installation Instructions page 3

FIG.A
Remove
FIG.B
FIG.C
21-024 www.powercommander.com
1 Remove the seat. Remove the fuel tank. Remove the airbox.
2 Disassemble the body work surrounding the tail section. Remove the side
panels and the cross-member bracket above the charcoal canister (Fig. A).
3 Secure the PCV module in the tail section rear of the charcoal canister with
the supplied Velcro. Use the supplied alcohol swab to clean surfaces before
attaching the Velcro (Fig. B).
4 Route the PCV wiring harness forward towards the engine long the right side
of the frame.
5 Secure the PCV ground wire with the small ring terminal to the stock common
ground bolt at the top of the engine case (Fig. C).
2018 Triumph Street Triple 765 - PCV - 3