Removing The Appliance; Electrical Connection - Bosch SHEM78WH5N Operating Instructions Manual

To change the setting:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press Info button 8 for
3 seconds until the following text
is indicated on the display window
at the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4. Keep pressing the button > )R
until water connection appears of
the display window at the top
@.
5. Make the selection with setting
buttons + -X.
6. Press and hold the Info button
8 for 3 seconds.
The chosen setting has now been
stored.
* optional feature which may or may
not be included with your dishwasher

Electrical connection

Connect the appliance to an 120
■
V, 60 Hz alternating current only,
via a correctly installed outlet with
protective grounding conductor.
See rating plate for required
fusing 9:.
The outlet must be near the
■
appliance and freely accessible
after the installation.
If the plug is not freely accessible,
an allpole disconnector with a
contact opening of at least 3 mm
must be fitted on the installation
side to satisfy the relevant safety
instructions.
The connection may be modified
■
by technicians only.
A power cord extension may be
■
purchased from customer service
only.
Installation and connection en-us
Use only a residual current
■
operated circuit-breaker which
features the symbol ‚. Only this
extension guarantees compliance
with the currently valid
regulations.
The appliance features a water
■
damage protection system.
Please note the system will
function only when the power
supply is connected.

Removing the appliance

Also observe
the sequence of worksteps here.
1. Disconnect the appliance from the
power supply.
2. Turn off the tap.
3. Undo the drain water and water
supply connection.
4. Loosen fastening screws for the
cabinet parts.
5. If fitted, remove the base panel.
6. Pull out the appliance, carefully
pulling the hose behind.
Transporting the appliance
Empty the dishwasher and secure
loose parts.
Drain the appliance according
to the following steps:
1. Turn on the tap.
2. Open the door.
3. Switch on ON/OFF button (.
4. Select wash cycle with the highest
temperature.
The estimated wash cycle
duration is indicated on the digital
display @.
5. Press START button )*.
6. Close the door.
Wash cycle sequence starts.
7. Open the door after
approx. 4 minutes.
61