Bosch SHEM78WH5N Operating Instructions Manual page 48

en-us Troubleshooting
Fault Cause
Dishes not dry. No or too little rinse aid in the
dispenser.
Wash cycle selected without drying. Select wash cycle with drying.
Water collecting in depressions on
the dishes and silverware.
The combined detergent used has
a poor drying performance
extraDry to increase drying not
activated.
Dishes were removed too early or
drying process had not ended yet.
The eco rinse aid used has a limited
drying performance.
Plastic dishes Special properties of plastic.
not dry.
Silverware not Silverware not arranged properly in
dry. the silverware basket.
Silverware not arranged properly in
the third rack.
Appliance No appliance fault.
interior wet
after rinse
cycle.
46
Remedial action
Refill rinse aid.
Arrange dishes in a sloping position,
arrange affected dishes as sloping as
possible.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Activate extraDry.
Wait until wash cycle ends or wait until 30
min after wash cycle ends before removing
dishes.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic has a lower heat storage capacity
and therefore dries less well.
Separate silverware if possible, prevent
contact points.
Arrange silverware properly and separate if
possible.
On account of the "Condensation drying"
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.