Important Safety Instructions To avoid possible injury or property damage, OBSERVE • NEW INSTALLATION - If the dishwasher is a new ALL WARNINGS AND CAUTIONS. installation, most of the work must be done before These instructions are intended for use by qualified the dishwasher is moved into place.
Page 3
WARNING Avoiding General Hazards Make sure electrical work is properly installed. There Do not use the dishwasher until it is completely should be no loose electrical connections. Ensure all installed. When opening the door on an uninstalled electrical connections are properly made. dishwasher, carefully open the door while supporting the rear of the unit.
Inspect the Dishwasher After unpacking the dishwasher and prior to installation, thoroughly inspect the dishwasher for possible freight or cosmetic damage. Report any damage immediately. Cosmetic defects must be reported within 30 days of installation. NOTE: Do not discard any bags or items that come with the original package until after the entire installation has been completed.
Materials Supplied Extra Tall Item Sprinkler (See Use and Care Manual) Toe Panel Screws Mounting Brackets Mounting Bracket Screws Ø 4x17 mm Toe Panel (2 pieces) Toe Panel caps and screws (select models only) Screw Clamp (for hose) Water Supply Adaptor Fitting Flexible Edge Protector Grommet for electrical wire Rubber Drain Hose Adaptor Toe Panel Mounting Brackets (select models only)
Enclosure Requirements After locating the proper place for your new dishwasher, WARNING you will need to create any required openings to allow for passage of the water, drain and electrical line. In order to Avoid Scalding or Electrical Shock Hazard! avoid interference with the dishwasher when sliding it into the Make sure the water supply and electrical supply cabinet, place your openings within the dimensions shown...
Electrical Preparation Electrical Preparation Electrical Connection The dishwasher electrical supply junction box (P) and WARNING dedicated receptacle must be mounted in an accessible cabinet adjacent to the dishwasher (do not mount the junction Avoid Electrical Shock Hazard box or receptacle behind the dishwasher). You will need a Do not work on an energized circuit.
Method B - To permanently connect to household or Inlet Water Connections field wiring: 1. Remove the dishwasher electrical supply junction box Hot Water Supply cover and connect to the power supply cord from the house installation. See Figure 7. The hot water heater should be set to deliver approximately 2.
Connecting the Hot Water Supply IMPORTANT NOTES: · If local ordinance require an air gap, install it according There are two plastic corrugated hoses that exit the back of to the manufacturer’s instructions. the dishwasher. The larger hose, with the brass fitting on the ·...
Top Mount is used for countertops made of wood or other Installation of Rubber Drain Hose Adaptor materials that can be easily drilled. Orient the mounting For a large port, use the drain hose as it is. brackets as shown in Figure 17 and position the two small 1.
Page 11
Drive the mounting screws through the holes in the mounting WARNING brackets as shown for Top Mount (Figure 23), Side Mount Avoid Tip Over Hazard! (Figure 24), and Alternative Side Mount (Figure 25). Do not use the dishwasher until it is completely Figure 23 installed.
Attaching the Toe Panel Figure 27 Your dishwasher comes with either a two-piece or three- piece toe panel (model dependent) to allow height adjust- ment. 1. Ensure the time projector is visible (depending on the model). Also when attaching the toe panel, ensure the distances are in the correct ranges.
Customer Service Your dishwasher requires no special care other than that described in the Care and Maintenance section of the Use and Care Manual. If you are having a problem with your dishwasher, before calling for service please refer to the Self Help section in the Use and Care Manual.
Need help?
Do you have a question about the SHEM78WH5N/32 and is the answer not in the manual?
Questions and answers