Care And Maintenance - Bosch SHEM78WH5N Operating Instructions Manual

en-us Care and Maintenance
Interrupting the wash cycle
CAUTION!
9
Expansion (overpressure) may
cause the appliance door to
jump open and/or water to
escape! If the door was opened
on an appliance which has a
hot water connection or is
heated, always leave the door
ajar for several minutes and
then close.
1. Open the door.
2. Switch off ON/OFF switch (.
The LEDs go out. The wash cycle
is saved.
3. To continue the wash cycle,
switch on the ON/OFF switch (
again.
4. Close the door.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button the operation will be
paused. Press the Start button again
and close the appliance door.
Terminating the wash cycle
(Reset)
1. Open the door.
2. Press the START button )* and
hold for 3 seconds
The digital display @ shows:
"Program was terminated".
3. Close the door.
The wash cycle sequence lasts
approx. 1 min. The digital display
@ shows: "Finished".
4. Open the door.
5. Switch off ON/OFF switch (.
6. Close the door.
40
Changing the wash cycle
When the START button ( has
been pressed, the wash cycle cannot
be changed. The only way a wash
cycle can be changed is by
terminating the wash cycle (Reset).
2
Care and
Maintenance
A regular inspection and
maintenance of your machine will
help to prevent faults. This saves time
and prevents future problems.
Overall condition of the
dishwasher
NOTICES
Never use a steam cleaner to
■
clean your dishwasher. The
manufacturer is not liable for any
resulting damage.
Regularly wipe the front of the
■
appliance with a damp cloth -
water and a small amount of
liquid soap is adequate. Do not
use sponges as they could
scratch the surfaces.
Stainless steel appliances: To
■
prevent corrosion, do not use
sponges or chlorine based
cleaners. Use a stainless steel
polish to seal and protect the
surface. Do not use chlorine
based cleaners or wipes.
Clean the outer edges of the
■
inside door panel regularly to
remove debris that may collect
from normal loading. If spots
begin to appear on the stainless
steel, make sure the rinse agent is
full and functioning properly.