Completing The Installation; Installation Options - STIEBEL ELTRON DEL 18 SL Operation And Installation

Electronically controlled instantaneous water heater
Hide thumbs Also See for DEL 18 SL:
Table of Contents

Advertisement

INSTALLATION
Installation
Adjustable connected load
With the DEL 18/21/24 SL, 3 connected load stages can be
selected. The middle load is preset. With a different connected
load, proceed as follows:
Select the connected load you require (see chapter
"Specification / Data table").
Plug in the coding card according to the selected connected
load.
Change the type plate. Tick the selected connected load.
Please use a ballpoint pen to do this.

10.2 Completing the installation

Open the 3-way ball shut-off valve.
Fit the lower part of the back panel. Ensure that it clicks into
place.
Align the mounted appliance by loosening the fixing toggle,
aligning the electrical connection and back panel, and then
re-tightening the fixing toggle. If the back panel of the appli
ance is not flush, the appliance can be secured at the bottom
with an additional screw.
31
| DEL SL electronic LCD

10.3 Installation options

-
Electrical connection from above on unfinished walls
-
Electrical connection on finished walls
-
Large cross-section for electrical connection from below
-
Connecting a load shedding relay
-
Water installation on finished walls
-
Water installation for finished walls with solder / compres
sion fitting
-
Water installation on finished walls, fitting the appliance
cover
-
Installation of lower back panel with threaded fitting on fin
ished walls
-
Use of existing wall mounting bracket when replacing an
appliance
-
Installation with offset tiles
-
Pivoting appliance cover
-
Operation with preheated water
-
Anti-scalding protection / temperature limit
Electrical connection from above on unfinished walls
Cut open the cable grommet for the power cable.
Push down the locking hook to secure the mains terminal.
Pull out the mains terminal.
-
Reposition the mains terminal in the appliance from the
bottom to the top and secure the mains terminal by sliding it
under the locking hook.
Route the control wires below the wire guide.
www.stiebel-eltron.com

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Del 27 slDel 21 slDel 24 sl

Table of Contents