Solid-State Drive (M.2) - HP Pavilion 15-bc000 Maintenance And Service Manual

Solid-state drive (M.2)

Description
Solid-state drive, 128 GB, SATA-3. TLC
Solid-state drive, 128 GB, SATA-3, Value
Solid-state drive, 256 GB, PCIe 3x4 SS, TLC
Solid-state drive, 512 GB, PCIe 3x4 SS, TLC
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the base enclosure (see
5. Disconnect the cable from the battery.
Remove the solid-state drive:
Remove the Phillips screw (1), and then pull the solid-state drive away from the connector (2).
▲
Reverse this procedure to install the solid-state drive.
Base enclosure on page 32).
Component replacement procedures
Spare part number
759848-032
827560-017
847109-005
847110-002
39