Mazda BT-50 2017 Owner's Manual page 46

Locks
qDriver configuration mode
NOTE
This operation has to be done within 30
seconds.
1. Switch the ignition ON.
2. Press door lock button three times.
3. Switch the ignition OFF.
4. Press door lock button three times.
5. Switch the ignition ON.
6. Press door lock button two times.
The system will chirp to indicate that the
driver configuration mode is enabled.
Once in driver configuration mode, follow
the steps mentioned below to toggle the
status of the automatic locking by speed
or automatic unlocking.
Automatic locking by speed
NOTE
Automatic locking by speed is default
disabled.
Press the central lock or unlock button
twice within three seconds and wait for
three seconds to toggle the automatic
locking by speed function. The system
will chirp when toggling.
Automatic unlocking
NOTE
Automatic unlock is default enabled.
40
Press the central lock or unlock button
three times within three seconds and wait
for three seconds to toggle the automatic
unlocking function.
If the automatic unlocking function is
enabled:
All doors will be unlocked while
l
opening the driver door or front
passenger door (vehicles not delivered
with remote control) from inside, with
the key in ignition.
If the automatic unlocking function is
disabled:
Only the respective door will be
l
unlocked while opening from inside.
NOTE
Opening the rear doors will never
unlock the other doors, when opened
from inside.
qLocking the doors individually
with the key
NOTE
If the central locking function fails to
operate, the doors can be individually
locked using the key in the position
shown.