Specifications And Requirements; Rough-In Drawings - Fetco CBS-1131-XV+ User's Manual & Operating Manual

Water Requirements:
CBS-1130 XV+: 20-75 psig, (138-517kPa) 2 gpm (7.60 lpm)
Water supplied to hot beverage equipment should be filtered
Water inlet fitting is a 3/8 inch male flare.
Brew Volume: Full Batch Up to 1 gallon/3.8 liters per brew
Total Brew Cycle—Factory setting: 5.5 minutes=[4 minute brew time + 1.5 minute drip delay]
Brew-Process parameters are user controllable for:
Brew Volume, Brew Time, Prewet Percent and Prewet Delay, Drip Delay
CBS-1131 XV+ Front
WIRING METHODS:
NEMA PLUG CONFIGURATION
G G
1
W
W
NEMA 5-15P NEMA 5-20P NEMA 6-15P
CBS-1131 XV+ 120 volt models with cord and plug
SKU E113172; E113173
Electrical installation, service and field conversion is to be made only by licensed electrician.
Go to fetco.com for the latest versions of all information

Specifications and Requirements

Rough-In Drawings

CBS-1132 XV+ Front
REFERENCE ONLY: SEE THE WIRING DIAGRAMS AT BACK OF THIS GUIDE
Disconnect equipment from power supply before service
Coffee Filter Size:
13" X 5" – standard FETCO # F002
Electrical: See electrical configuration chart.
Temperature, as set by factory:
200°F (93°C) inside water tank (at sea level)
CBS-1131 XV+&CBS-1132 XV+ Side
CBS 1132XV+ models 200-240 volt L1, L2,G
CBS-1131XV+ models for 200-240 volt
User Guide & Operator instructions
Page 2
P166 Re0 NOVEMBER 2017