Mirage IVEH121A Owner's Manual page 9

Setting Angle of Air Flow
Setting Angle of Air Flow
While the unit is on, use the SWING/DIRECT
button to set the direction (vertical angle) of
airflow.
1. Press the SWING/DIRECT button once to
activate the louver. Each time you press the
button, it will adjust the louver by 6°. Press the
button until the direction you prefer is reached.
2. To make the louver swing up and down
continuously, press and hold the SWING/DIRECT
button for 3 seconds. Press it again to stop the
automatic function.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set
manually. Grip the deflector rod (See Fig.B)
and manually adjust it to your preferred direction.
For some units, the horizontal angle of the airflow
can be set by remote control. please refer to the
Remote Control Section.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long pe-
riods of time. This can cause water to con-
dense on the louver blade, which will drop
on your floor or furnishings. (See Fig.A)
When using COOL or HEAT mode, setting
the louver at too vertical an angle can re-
duce the performance of the unit due to
restricted air flow.
Do not move louver by hand. This will cause
the louver to become out of sync. If this oc-
curs, turn off the unit and unplug it for a few
seconds, then restart the unit. This will reset
the louver.
Fig. A
CAUTION
Do not put your fingers in or near the
blower and suction side of the unit. The
high-speed fan inside the unit may cause
injury.
Fig. B
9