Mirage IVEH121A Owner's Manual page 29

Using the remote controller holder (optional)
The remote controller can be attached to a wall
or pillar by using a remote controller holder(not
supplied, purchased separately).
Before installing the remote controller, check that
the air conditioner receives the signals properly.
Install the remote controller with two screws. For
installing or removing the remote controller, move
it up or down in the holder.
Replacing batteries
The following cases signify exhausted batteries.
Replace old batteries with new ones.
Receiving beep is not emitted when a signal is
transmitted.
Indicator fades away.
The remote controller is powered by two dry bat-
teries (R03/LR03X2) housed in the back rear part
and protected by a cover.
(1) Remove the cover in the rear part of the
remote controller.
(2) Remove the old batteries and insert the new
batteries, placing the(+) and (-) ends correctly. (3)
Install the cover back on.
NOTE: When the batteries are removed, the
remote controller erases all programming. After
inserting new batteries, the remote controller
must be reprogrammed.
CAUTION
Do not mix old and new batteries or batteries of
different types.
Do not leave the batteries in the remote controller
if they are not going to be used for 2 or 3 months.
Do not dispose batteries as unsorted municipal
waste. Collection of such waste separately for
special treatment is necessary.
29