Cruise Control System - Skoda CITIGO Owner's Manual

Hide thumbs Also See for CITIGO:
Table of Contents

Advertisement

Function
Fig. 128 Fitting the sensors / Range of the sensors
Read and observe
and
The system uses ultrasound waves to calculate the distance between the
bumper and an obstacle. The ultrasonic sensors are integrated in the rear
bumper
» Fig.
128.
Approximate range of sensors
» Fig. 128
150 cm
A
B
60 cm
Audible signals
The interval between the acoustic signals becomes shorter as the clearance is
reduced. At a distance of approx. 30 cm a continuous tone starts to sound -
danger area.
Activation/deactivation
The system is activated by engaging reverse gear. When activated an audible
signal is heard.
The system is deactivated by disengaging reverse gear.
Fault display
If a warning signal sounds for 3 seconds after activating the system and there
is no obstacle close to your car, this indicates a system fault. Seek help from a
specialist garage.
on page 96 first.
Display in the swing radio display
Read and observe
and
Function keys and display
» Fig. 129
Switching audible parking signals on/off.
Switching off park assistant display.
There is an obstacle in the collision area (the distance to the obstacle
is less than 30 cm).
Stop moving in the direction of the obstacle!
An obstacle is located outside of the collision range (the distance to
the obstacle is greater than 30 cm).

Cruise Control System

Introduction
The Cruise Control System (CCS) maintains a set speed without you having to
actuate the accelerator pedal. The state where the GRA maintains the speed is
referred to hereinafter as the control.
WARNING
The general information relating to the use of assistance systems must be
observed
» page 95,
in section Introduction.
Fig. 129
Function keys and dis-
play
on page 96 first.
Assist systems
97

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents