Skoda CITIGO Owner's Manual page 127

Anti-theft wheel bolts
The anti-theft wheel bolts protect the wheels from theft. This can only be
» Fig. 152 loosened / tightenedwith attachment
›
Insert the upper section on the anti-theft wheel bolt
B
›
Insert the key as far as it will go onto attachment
wheel bolt.
›
Remove the attachment.
The attachment for the anti-theft wheel bolts must always be kept in the
vehicle in case of a possible wheel change!
For wheel trims supplied ex-factory or from ŠKODA Original Accessories, the
anti-theft wheel bolt should be installed in the position marked on the back of
the wheel trim.
Note
We recommend that you retain the label with the code number. A replacement
upper section can be acquired from ŠKODA Original Parts based on this.
Loosening/tightening wheel bolts
Fig. 152
Anti-theft wheel bolt and at-
tachment
.
B
until it stops.
A
and loosen / tighten the
B
Fig. 153
Loosening the wheel bolts
›
Insert the wheel wrench onto the wheel bolt to the stop. Use the associated
attachment for the anti-theft wheel bolts
›
To loosen the screws, grasp the key end and turn the screw about one turn
rotation in the direction of the arrow
›
Totighten the screws grasp the key end and turn the screw about against
the direction of the arrow » Fig.
WARNING
If it proves difficult to undo the bolts, carefully apply pressure to the end of
the wrench with your foot. Keep hold of the vehicle when doing so, and
make sure you keep your footing - danger of injury.
Raising the vehicle
Fig. 155 Attach lifting jack
Before the vehicle is raised, please take note of the safety instructions
Use the jack from the tool kit to raise the vehicle. Position the jack at the jack-
ing point closest to the wheel to be replaced.
» Fig. 152 on page 125.
» Fig. 153.
153, until it is tight.
Fig. 154
Jacking points for the jack
Emergency equipment and self-help
» .

125