Tyre Pressure Monitoring - Skoda CITIGO Owner's Manual

Disable / Enable

Read and observe and
The function is automatically activated each time the ignition is switched on.
›
to deactivatehold the button» Fig. 132
The appropriate message and the indicator light appears   flashes several
times in aquicker sequence (the   lights up at a speed of 5-30 km / h).
›
To activate hold the button» Fig.
The appropriate message and the warning light appears   in the display of
the instrument cluster.
WARNING
For safety reasons, deactivate the system in the following situations.
When the vehicle is being towed away.
■
When the vehicle is driven though an automatic car wash.
■
If the laser sensor is damaged or faulty.
■
When the vehicle is on a rolling test bench.
■
When the windscreen is damaged in the region of the laser sensor.
■
For example, if the charge extends to the roof rack over the front edge of
■
the roof.

Tyre pressure monitoring


Introduction
The tyre pressure monitoring function (hereinafter referred to as: the system)
monitors the tyre pressure while driving.
100
Driving
Fig. 132
Button for the City Safe Drive
system
on page 98 first.
until a beep sounds.
132until a beep sounds.
If the tyre inflation pressure changes, the warning light
strument cluster and an audible signal is
The system can only function properly if the tyres have the prescribed inflation
pressure and these pressure values are stored in the system.
WARNING
The general information relating to the use of assistance systems must be
■
observed » page 95, in section Introduction.
Having the correct tyre inflation pressure is always the driver's responsi-
■
bility. Tyre pressure should be checked regularly
The system cannot warn in case of very rapid tyre inflation pressure loss,
■
e.g. in case of sudden tyre damage.
Storing the tyre pressure values.

Read and observe on page 100 first.
Procedure for storing the tyre pressure values
›
Inflate all the tyres to the specified pressure.
›
Switch on the ignition.
›
Press down  » Fig. 133 on the button and hold.
The warning light lights up in the instrument cluster.

An acoustic signal sounds and the warning light extinguishes, indicating that
the tyre pressure values have been stored.
›
Release  the button.
lights up in the in-

heard» page 28, Tyre pressure.

» page 118.
Fig. 133
Key for storing the pressure val-
ues
