Operation
Fig. 38 Operation of the sliding/tilting roof
Read and observe
and
Operation of the sliding/tilting roof
Open fully
Open to the low-noise position
Open partially
A
Close completely
Opening (switch in position )
1
Resetting (switch in position )
2
After turning the switch one stop to position (spring-tensioned position),
the tilt / slide sunroof stops in the position in which the intensity of the wind
noise is low. After turning the switch further to position , the tilt / slide sun-
roof opens up to the stop.
Force limiter
Read and observe
and
The sliding/tilting roof is fitted with a force limiter.
If there is an obstacle, the closing process is stopped and the glass pane re-
tracts by several centimetres.
42
Using the system
on page 41 first.
» Fig. 38
on page 41 first.
WARNING
If the tilt / slide sunroof is closed, by pulling on the recess of the switch in
the direction of arrow
2
,
» Fig. 38
hindered by an obstacle, then at the third attempt at closing, the force limi-
tation will cease to function (if less than 5 s passes between the individual
attempts to close). The tilt / slide sunroof closes with full force - this can
cause injury.
Activate operation of the tilt / slide sunroof
Read and observe
and
If the tilt / slide sunroof stops working (e.g. after disconnecting and connect-
ing the battery), then the operation must be reactivated.
›
Turn on the ignition and set the switch to position
›
Press the switch on the recess E down and pull forwards.
The sliding/tilting roof opens/closes again after around 10 seconds.
›
Release the lever.
Manually operated sunblind
Read and observe
and
›
To open, pull the handle in the direction of arrow
›
To close, pull the handle in the direction of arrow
on page 42 and the closing process is
on page 41 first.
» Fig. 38
on page 42.
Fig. 39
Operation of the sunblind
on page 41 first.
A
» Fig.
39.
.
B